Blowpin Receptacle with quick change system
We have the proven Blowpinholder system improved with quick release to another positive detail.
With longer use of this Blowpinholder could find that the screw spindels are loose in the housing to set the
Blowpin. The lock nuts were glued in and the nuts has only 4 mm holes to unscrew it from the housing.
Had they not built a special tool one is just gone with a snap ring pliers or a hammer and a screw driver to work and
tried to figure out this. This usually ended with the destruction of the lok nut ( bronze ) and the tools.
Therefore, we have milled a 10 mm Imbus hole in the nut and therefore give the operator the opportunity to unscrew
this by possible higher effort.
This Blowpinholder are very complex and also very expensive to produce. We have now found a to change in
required materials and surface treatment of the materials have a way to reduce these manufacturing costs.
We would also like to pass on to our customers.
See for yourself and request a quote from us.
You will be amazed.